A program to process channels.conf files.
szap [options]
This manual page documents briefly the szap commands.
szap is a program to process a channels.conf file.
-n channel-number | channel_name
zap to channel via number or full name (case insensitive)
-q
list known channels
-a number
use given adapter (default 0)
-f number
use given frontend (default 0)
-d number
use given demux (default 0)
-c file
read channels list from 'file'
-b
enable Audio Bypass (default no)
-x
exit after tuning
-H
human readable output
-r
set up /dev/dvb/adapterX/dvr0 for TS recording
-l lnb-type (DVB-S Only) (use -l help to print types) or
-l low[,high[,switch]] in Mhz
-i
run interactively, allowing you to type in channel names
-p
add pat and pmt to TS recording (implies -r) or -n numbers for zapping
This manual page was written by Uwe Bugla <[email protected]>.